Loại ar · chủ đề 35.30 · phiên bản 0104 · 2001-07-24
Áp dụng cho: REAR AXLE 741.130 /131 /404 /405 /408 /436 /438 /439 /52 /530 /540 /55 with CODE (A71) Rear axle with differential lock REAR AXLE 741.407 with CODE (A71) Rear axle with differential lock with CODE (AC7) Rear axle ratio i = 3.272 with CODE (AE1) Rear axle ratio i = 2.923 REAR AXLE 741.130 /408 in MODEL 690.6 with CODE (A71) Rear axle with differential lock
Không có bằng “vi”; đang hiển thị bằng tiếng Anh.
Vị trí
Nhóm chức năng 2 Chassis › 35 Rear axle › 35.30 Final drive, drive shafts — Dòng 690 (mẫu 6**)
Cũng áp dụng cho động cơ/hộp số: 741 130, 741 131, 741 404, 741 405, 741 407, 741 408, 741 436, 741 438, 741 439, 741 52*, 741 530, 741 540, 741 55*
AR35.30-D-4815-02B
Measuring basic dimension on differential
601 589 00 21 00
Adjustment device
460 589 03 63 00
Ring
D35.30-0072-01
AMeasuring internal dimension of axle housing
1 Push spacer ring () onto left-hand side of measuring device (02, ).
2 Install measuring device (02, ) in rear axle housing and measure gap using feeler gauge (a).
2 Determine internal dimension of housing and note measurement. The internal dimension is calculated by adding the size of the special tool and the measurement for the gap.
Example: Special tool size 163.8 mm
Feeler gauge gap 1.1 mm
Internal housing dimension164.9 mm
D35.30-0073-01
BMeasuring differential
1 Place differential on a level surface with one 5mm thick shim at the top and another at the bottom, and meaasure the overall height (arrows).
Example: Differential measured with shims 164.1 mm
