Intake manifold, intake manifold preheater
D09.20-0019-01
1 Detach wiring loom (1) from intake manifold and from intermediate flange (ararows).
Installation: When fitting on the wiring loom, ensure the wiring looms are correctly routed in the area of the intermediate flange.
D09.20-0020-01
2 Unplug connector (3) from camshaft position sensor (2).
D09.20-0021-01
3 Take off strut (4) of power steering pump at intake manifold (5) and at power steering pump (6) and place to the side together with the clipped-on line.
D09.20-0022-01
4 Run wiring loom (1) together with connectors of ignition coils, of injectors, of actuator and of purge control valves and air shutoff valves, down and out of the intake manifold.
D09.20-0023-01
5 Take intake manifold (8) off the cylinder head.
6 Take intake manifold gasket (7) off the cylinder head.
Installation: Clean sealing surface at cylinder head and intake manifold. Replace gasket (7). When fitting on, pay attention to the two centering sleeves at the cylinder head.
Pay attention to tightening torque for nuts and bolts.
7 Fit on in the reverse order.