ar0704d0100sd
Remove/install intake manifold pressure sensor
Loại ar · chủ đề 07.04 · phiên bản 0107 · 2014-11-28
Áp dụng cho: ENGINE 642, 646, 651 in MODEL 906 ENGINE 651 in MODEL 900
Không có bằng “vi”; đang hiển thị bằng tiếng Anh.
Vị trí
Nhóm chức năng 1 Engine › 07 Mixture formation › 07.04 Sender, Feeler, Sensors — Dòng 646 · Dòng 651 · Dòng 900 · Dòng 906
EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Dòng 646 · Dòng 651 · Dòng 900 · Dòng 906
Cũng áp dụng cho động cơ/hộp số: 642 ***
AR07.04-D-0100SD
| Remove/install intake manifold pressure sensor
| 20.11.2014
|
ENGINE
| 642, 646, 651 in MODEL 906
|
ENGINE
| 651 in MODEL 900
|
1
| Electrical connection
|
| B28
| Intake manifold pressure sensor (for engine 642.992/993, 646)
|
| B28/19
| Intake manifold pressure sensor (for engine 642.896/898)
|
2
| Air filter housing
|
| B28/17
| Intake manifold pressure sensor (for engine 651)
|
|
|
|
| Remove/install
|
|
|
1
| Disconnect electrical connection (1) at intake manifold pressure sensor (B28, B28/17 or B28/19)
|
|
|
2
| Remove screw/bolts on intake manifold pressure sensor (B28, B28/17 or B28/19)
|
|
|
3
| Pull the intake manifold pressure sensor (B28, B28/17 or B28/19) out of the air filter housing (2)
| Installation: Check O-ring and replace if necessary.
|
|
4
| Install in the reverse order
|
|
|
