W26.45-0009-11
1 Sealing gasket
2 Sealing ring
3 Back closing cover
4 Screw
| Install | ||
1 | Remove the back closing cover (3) | Clean the sealing surface. | |
2 | Remove the driven shaft and the driven flange on the secondary shaft | ||
3 | Install the power take-off | ||
4 | Install the driven flange on the secondary shaft and the driven shaft | Observe for the correct positioning of the sealing ring. | |
5 | Install the compressed air pipe in the power plug socket drive cylinder | To install the compressed air pipe from the power plug socket pneumatic system in vehicles that did not previously have the power plug socket, it is necessary to cut the electropneumatic valve air tube in the gearbox in an average position and install: The "T" connection and the coupling mouth system that are part of the power plug socket installation kit. | |
6 | Perform the parametrization on the ADM module |