ar6830p4785rk

Remove/install paneling on rear center section

Tür ar · konu 68.30 · sürüm 0100 · 2013-03-11

Geçerli olduğu: MODEL 231

“tr” dilinde mevcut değil; İngilizce gösteriliyor.

Konumu

Fonksiyon grubu 3 Karoseri › 68 İç donanım › 68.30 Kaplama, Çıtalar — Seri 231

EinPAS 37 İç donanım › 37.45 Kaplama › 37.45.34 Bagaj kaplaması — Seri 231

EinPAS 37 İç donanım › 37.45 Kaplama › 37.45.35 Yükleme bölmesi kaplaması — Seri 231

AR68.30-P-4785RK

Remove/install paneling on rear center section

25.02.2013

MODEL

231

Remove/install paneling on rear center section

1

Cover

2

Rear center section paneling

3

Clip

4

Nut

5

Trunk floor paneling

P68.30-3672-06

Remove/install paneling on rear center section

P68.30-3686-08

2

Rear center section paneling

X58/4

Luggage compartment socket

X58/23

Charger feed-in socket

Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Notes on sensor system for trunk lid opening/closing

AH80.61-P-0001-01A

Remove/install

1

Open trunk lid

2

Switch off ignition and remove transmitter key (A8/1) or KEYLESS-GO start/stop button (S2/3) from electronic ignition lock control unit (N73)

KEYLESS-GO start/stop button (S2/3) only with code (889) KEYLESS-GO.

3

Remove trunk floor paneling (5)

4

Remove spare tire well panel

5

Unscrew nuts (4)

6

Positioning trunk lid to assembly position

Do not open trunk lid completely. Actuate vario roof (S84s1) only until the rear side windows are lowered approx. half way.
Do not install support.

7

Remove cover (1) from striker

Mounting wedge

*110589035900

8

Remove rear center section paneling (2)

Unclip clips (3) from rear center section.

Installation: Ensure that rear center section paneling (2) is seated correctly below seal on rear center section.

9

Disconnect electrical connector from trunk socket (X58/4)

10

Disconnect electrical connector from charger feed power outlet (X58/23)

Vehicles with CODE 675 (preinstallation for battery charger)

11

Remove rear center section paneling (2)

12

Open trunk lid

13

Remove trunk socket (X58/4)

When replacing rear center section paneling (2).

AR54.10-P-1000RK

14

Release charger feed socket (X58/23) and remove

Vehicles with CODE 675 (preinstallation for battery charger)
When replacing rear center section paneling (2).

15

Install in the reverse order

Remove/install paneling on rear center section

110 589 03 59 00

Mounting wedge

Atıfta bulunulan belgeler