Special procedures must be followed during care, cleaning and repair.
Post-repair refinishing:
A repair solution for matt paintwork has been developed with all approved paint partners.
The repair paintwork is applied in the normal way with the exception of the matt clearcoat repair systems which are to be used.
-----------------------------------------------------------------------------------------
The following special considerations should be observed:
Paint repair:
Before post-repair refinishing, the production of a spray sample with base coat and clearcoat is strongly recommended for checking the color and luster.
The luster can also be measured using a commercially available reflectometer. In the case of "Magno matt paintwork" it is 23 %E (7) when measured at a 60 ° angle.
Painting the parts "edge to edge" is recommended. If this is not possible, we recommend a large repair of the entire damaged side of the vehicle.
-----------------------------------------------------------------------------------------
Furthermore, spot repairs and touchups on parts are not recommended. In the event of repair, the entire component must be repaired i.e. the entire door must be coated with matt clearcoat, for example.
Final operations:
It is not possible to polish visible defects such as dirt or paint runs out of the last clearcoat layer because polishing results in visible differences in luster. For this reason, extreme cleanliness is important during repair. Any dirt inclusions must be removed before the last spray application of clearcoat.
No special working hours values have been created for matt paintwork because the repair procedure is the same as normal apart from the special considerations listed above.
The specifications of the repair paint manufacturers must always be followed during repair. These are found in the After-Sales Paint Technology Guide (https://portal.aftersales.i.daimler.com).
-----------------------------------------------------------------------------------------
Cleaning and care
Maintenance
To preserve the matt surface, paint cleaners, abrasive and polishing products as well as gloss preservers (wax) must not be applied to the paintwork.
It is especially important not to polish the vehicle. Polishing will cause glossy patches in the matt surface.
If polishing is performed, the matt effect can only be restored by painting again.
Excessive rubbing with unsuitable products can also cause brightening.
Frequent use of unsuitable washing facilities can increase the luster.
-----------------------------------------------------------------------------------------
Cleaners:
The following rules must be strictly followed for matt clearcoat:
The vehicle should preferably be washed by hand with a soft sponge, neutral soap and plenty of water. Frequent use of washing facilities can increase the luster and thus lessen the matt effect.
Always avoid washing in direct sunlight.
Any adhering insects or bird lime should be removed immediately. Soaking with water and use of a high pressure cleaner is recommended. In the case of difficult-to-remove insects, these should first be sprayed with insect remover (see Repair materials table).
If you have further questions regarding the topic "Matt paintwork", please contact the contact persons of your paint partners.
Repair materials
Number | Designation | Order number |
BR00.45-Z-1021-04A | Insect remover | A 001 986 39 71 |