Shown on right side of vehicle |
1 | Cover |
2 | Screw |
3 | Belt |
4 | Seat belt guide bracket |
5 | Center C-pillar trim |
6 | Screw |
7 | Screw |
8 | Electrical connector |
S91.40-4632-06
Warning | Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts. | |
Caution | Risk of injury. Injury may result when the tension in the spring in the automatic belt retractor is released. | Never disassemble automatic belt retractors. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Topical note | Notes on carrying out repair work in the vehicle interior | ||
Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | |||
| Remove/install | ||
1 | Disconnect ground line on on-board electrical system battery | ||
2 | Remove lower C-pillar trim | ||
3 | Unclip cover (1) above screw/bolt (2) | Clip remover | |
4 | Unscrew screw/bolt (2) and guide seat belt strap (3) together with seat belt guide bracket (4) out of center C-pillar trim (5) | Installation: | |
Bolt, seat belt guide bracket for rear seat belt to bracket | |||
5 | Remove bolt (6) | Bolt, seat belt guide of rear seat belt to rear panel | |
6 | Unscrew bolt (7) | Bolt, bracket of seat belt retractor for rear seat belt to vehicle floor | |
7 | Disconnect electrical connector (8) and take out seat belt | ||
8 | Install in the reverse order | ||
| Check | ||
9 | Check Supplemental Restraint System (SRS) with diagnostic system | After installing new seat belt. | |
| |||
10 | Perform function check of seat belt and seat belt buckle |
452 589 01 63 00
Clip remover