Shown on vehicle with ENGINE 272 |
1 | Radiator trim |
2 | Bracket |
3 | Left air intake pipe |
4 | Engine hood cable |
5 | Right air intake pipe |
6 | Mounting clip |
7 | Cold air intake bridge |
P88.40-2881-06
1 | Radiator trim |
8 | Front bumper |
9 | Screw |
P88.40-2882-06
| Remove/install | ||
1 | Open engine hood | ||
2 | Remove intake air guide from cold air intake bridge (7) to engine cover | Model 207 with engine 642 | |
3 | Remove left air intake pipe (3) | Model 207 with engine 271, 272, 273, 276, 278, 642, 651 | |
4 | Remove right air intake pipe (5) | Model 207 with engine 272, 273, 274, 276, 278, 642 | |
5 | Unhook engine hood cable (4) at holders (2) | ||
6 | Detach retaining clip (6) by turning and remove | ||
7 | Release cold air intake bridge (7) at catch hooks (arrows A and B) and remove | ||
8 | Remove screw/bolt (9) | ||
9 | Disengage catch hooks (arrows C) on radiator trim (1) | Installation: Ensure that catch hooks (arrows C) are seated correctly in recesses (arrows E) in front bumper (8). | |
10 | Disengage catch hooks (arrows D) of radiator trim (1) on front bumper (8) | Installation: Ensure that catch hooks (arrows D) are seated correctly in recesses (arrows F) in front bumper (8). | |
11 | Expose electrical connector for front 360° camera from radiator trim (1) and disconnect | Model 207 as of 6/1/13 | |
12 | Remove radiator trim (1) toward front from front bumper (8) | ||
13 | Install in the reverse order | ||
14 | Calibrate front 360° camera using the diagnostic system | Model 207 as of 6/1/13 | |
|