1 | Bumper |
4 | Vent grille |
5 | Screw |
B14 | Outside temperature display temperature sensor |
X26/27 | Front PTS separation point |
P88.20-2322-06
6 | Screw |
7 | Screw |
8 | Screw |
P88.20-2323-06
| Remove/install | ||
Danger | Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC. | No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers. | |
1 | Disconnect battery ground line | ||
Topical note | Notes on battery | ||
2 | Open engine hood and move to vertical position | ||
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
3 | Raise vehicle with vehicle lift | ||
4 | Detach lower engine compartment paneling | ||
5 | Remove fender liner front section in front fender | ||
Left and right side. | |||
6 | Unclip outside temperature display temperature sensor (B14) | ||
7 | Disconnect front PTS separating point (X26/27) | First open lock. | |
8 | Unscrew screws (5) and remove vent grille (4) | ||
9 | Remove screws (6) behind vent grille (4) | ||
10 | Remove screws (7) from bumper (1) | ||
11 | Remove screws (8) in front wheel arch | In each case, three screws in left and right wheel arch. | |
12 | Pull bumper (1) towards front out of side guide | | |
Use aid of helper. | |||
13 | Install in the reverse order |