AR83.70-W-5975B | Remove/install temperature sensor | 6.6.96 |
MODEL 950, 952, 953, 954 with BODY 942.899 with CODE (H64) Eberspächer D9W hot water auxiliary heater
1 Tie strap
2 Tie strap
3 Cap
4 Cable retainer
5 Flat connector
6 Connector
7 Electrical line
8 Temperature sensor
9 Heat exchanger housing
10 Sealing ring
W83.70-0006-03
| Remove/Install | ||
1 | Disconnect ground lead from battery | Do not interrupt main battery current in heater mode or in the run-on phase. | |
Danger! | Risk of injury caused by body parts being jammed and crushed when tilting cab | Ensure that no one is within the tilting range of the cab during tilting. Always tilt the cab all the way to the end position and secure with the safety strut. | |
2 | Tilt cab | ||
3 | Remove auxiliary heater control unit | ||
4 | Remove tie straps (1) and (2) | ||
5 | Detach cap (3) of cable retainer (4) | | |
6 | Fold up cable retainer | ||
7 | Unclip flat plug (5) of chamber nos. 9 and 11 from connector housing (6) | | |
8 | Pull electrical line (7) through to temperature sensor (8) | ||
9 | Remove temperature sensor with sealing ring (10) from heat exchanger housing (9) | | |
10 | Install in the reverse order | ||
Danger! | Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed areas or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | |
11 | Check function of stationary heater |
Stationary heater unit
Number | Designation | Models | ||
BA83.70-N-1006-03A | Bolt, cap on burner housing | Nm | 3.5 | |
BA83.70-N-1014-03A | Temperature sensor to heat exchanger housing | Nm | 3 | |
655 589 06 63 00
Contact release