AR83.70-W-5807B | Removing and installing combustion and hot air blower | 1.8.96 |
MODEL 950, 952, 953, 954 with BODY 940.899 with CODE (H62) Warm air heater "Eberspächer D3 LP"
MODEL 950, 952, 953, 954 with BODY 942.899 with CODE (H62) Warm air heater "Eberspächer D3 LP"
MODEL 970, 972, 974, 975, 976 with BODY 972.899 with CODE (H62) Warm air auxiliary heater "Eberspächer" D3 LP
W83.70-0049-06
1 Phillips screw
2 Combustion and hot air blower
3 Gasket
4 Connector for flame sensor
5 Connector for overheat switch
6 Phillips screw
7 Cover plate
8 Sealing ring
9 Gasket
10 Heat exchanger
| Removal, installation | ||
1 | Remove housing shells | ||
2 | Remove glow plug | ||
3 | Disconnect connector (4) for flame sensor and connector (5) for overheat switch | ||
4 | Remove hot air blower (2) | ||
5 | Remove cover plate (7), gasket (9) and gasket (3) | Installation: Replace gasket and adhesive gasket | |
6 | Remove sealing ring (8) from heat exchanger | Installation: Replace sealing ring. | |
7 | Install in opposite order | ||
Danger! | Fuel vapors present an explosion hazard. Combustion gases are toxic when inhaled. Heater can cause severe burns during and after operation. | Do not start up or operate stationary heaters, auxiliary heaters or engines with heater boosters in closed rooms or in the vicinity of service stations. Allow heater to cool off after operation and wear protective gloves. | |
8 | Check stationary heater for proper operation |