Bleeding coolant circuit after installing stationary heater

ประเภท ar · หัวข้อ 83.70 · เวอร์ชัน 0105 · 1999-10-07

ใช้กับ: MODEL 168 with ENGINE 668.940 /941 with Thermo Top C heater booster or stationary preheater MODEL 202 with ENGINE 611.960 with Thermo Top C heater booster or stationary preheater MODEL 210.### ## as of 394036 with ENGINE 602.982, 611.961, 612.961, 613.961 mit Zuheizer oder Standvorwärmung Thermo Top C'

ไม่มีใน “th” แสดงเป็น อังกฤษ

AR83.70-P-5302-01D	Bleeding coolant circuit after installing stationary heater
 Danger!	Heater booster, toxic combustion gases and severe burn hazard during and after operation	Do not start up or operate engines with heater booster in closed rooms. Allow heater to cool off after operation and wear protective gloves	AS83.70-Z-0002-01A
 Danger!	Danger of severe burns to skin and eyes from hot coolant spewing out. Coolant is toxic when swallowed	Open cooling system only when coolant temperature is below 90 °C. Open cover slowly and reduce pressure. Do not fill beverage containers with coolant. Wear protective gloves, protective clothing and protective goggles.	AS20.00-Z-0001-01A

1 Add coolant caught while removing heater to coolant expansion reservoir.

2 Close cap on expansion reservoir.

3 Set vehicle heater to "max".

4 Start vehicle engine and allow to warm up to operating temperature (approx. 80°C).

 Check heater and coolant lines for leakage while engine is warming up.

5 Shut off vehicle engine after reaching operating temperature.

6 Check coolant level in expansion reservoir and add coolant if necessary.

Bleeding coolant circuit after installing stationary heater

เอกสารที่อ้างถึง