W83.55-1051-09
1 | Refrigerant compressor | 3 | Refrigerant lines | ||||
2 | Electrical connector | 4 | Bolts |
1 | Refrigerant compressor |
8 | Refrigerant lines |
9 | Bracket |
W83.55-1050-11
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
Warning | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
Danger | Risk of explosion caused by welding or soldering work on closed air conditioning system. Risk of poisoning caused by inhaling overheated refrigerant vapors. Risk of injury to skin and eyes caused by contact with liquid refrigerant. | Never perform welding work on or near a closed air conditioning system. No smoking or open flames. Wear safety glasses and protective gloves. Work only in well ventilated areas. Carry out repair work on the air conditioning system circuit only after the system has been drained. | |
Topical note | Notes on tilting the cab | ||
Topical note | Protect air conditioning circuit and components from moisture when carrying out repair work | ||
Topical note | Procedure for a damaged or leaky air conditioning system | ||
Notes on handling refrigerant R134a | |||
| Remove/install | ||
1 | Switch off ignition | ||
2 | Drain air conditioning system | ||
3 | Tilt cab | ||
4 | Slacken off poly-V-belt and remove from refrigerant compressor (1) | ||
Belt drive routing diagram | |||
Installation: Check condition of poly-V-belt. | |||
If damaged. | |||
| |||
Install new poly-V belt. | |||
| Damage profiles for a poly-V belt | ||
Remove/install basic belt drive poly-V belt | |||
5 | Remove cable tie from electrical connector (2) | ||
6 | Separate electrical connector (2) of magnetic clutch | ||
7 | Remove refrigerant lines (3) at connecting point | Seal off connections of refrigerant lines (3). | |
Installation: Replace sealing rings and moisten with compressor oil. | |||
Refrigerant line separating point | |||
8 | Remove bolts (4) and remove refrigerant compressor (1) | Bolt, refrigerant compressor to cylinder crankcaseBolt, refrigerant compressor to cylinder crankcase | |
9 | Remove refrigerant lines (8) with holder (9) from refrigerant compressor (1) | Only if the A/C compressor (1) is replaced. | |
Bolt, refrigerant line to A/C compressor | |||
10 | Correct oil level in A/C compressor (1) | Only if the A/C compressor (1) is replaced. | |
11 | Install in the reverse order |