AR83.25-D-1124A | Remove and install air conditioning pushbutton control module | 3.9.99 |
MODELS 901.6, 902.6, 903.6, 904.6, 905.6
with CODE (H25) Automatic heater control "Heatmatic"
with CODE (HH9) Automatic air conditioning "Tempmatic"
MODEL 690.6 with CODE (HH9) Automatic air conditioning "Tempmatic"
D83.20-1101-11
1 Air conditioning pushbutton control module
2 Cable
3 Cable
4 Connector
5 Connector
6 Screw
7 Bracket
| Remove/install | ||
1 | Disconnect ground lead of battery | ||
2.1 | Remove stowage compartment below pen holder | Except code J19/J05, tachograph | |
2.2 | Remove tachograph | With code J19/J05, tachograph | |
3 | Remove cover on center part of instrument panel | ||
4 | Unscrew screws (6) | ||
5 | Identify cables (2 and 3) and remove from the air conditioning pushbutton control module (1) | Installation: The cable for the lower adjusting lever must be attached to the front adjusting knurl of the air conditioning pushbutton control module | |
6 | Remove plugs (4 and 5) | ||
7 | Unscrew bracket (7) on both sides | Only if the air conditioning pushbutton control module is replaced | |
8 | Install in the reverse order | ||
9 | Set time on instrument cluster | Except code J19/J05, tachograph | |
10 | Set time on timer for auxiliary heater | With code H12, hot-water auxiliary heater or code H86, timer for auxiliary heater | |
11 | Code radio if necessary |