ar8325d1124a

Remove and install air conditioning pushbutton control module

Type ar · topic 83.25 · version 0102 · 2001-09-10

Applies to: MODELS 901.6, 902.6, 903.6, 904.6, 905.6 with CODE (H25) Automatic heater control "Heatmatic" with CODE (HH9) Automatic air conditioning "Tempmatic" MODEL 690.6 with CODE (HH9) Automatic air conditioning "Tempmatic"

Where it sits

Function group 3 Body › 83 Climate control › 83.25 Automatic heater — Series 690 (models 6**) · Series 901 (models 6**) · Series 902 (models 6**) · Series 903 (models 6**) · Series 904 (models 6**) · Series 905 (models 6**)

EinPAS 39 Heating/ventilation/cooling › 39.15 Climate control › 39.15.11 Control unit/relay — Series 690 (models 6**) · Series 901 (models 6**) · Series 902 (models 6**) · Series 903 (models 6**) · Series 904 (models 6**) · Series 905 (models 6**)

EinPAS 39 Heating/ventilation/cooling › 39.15 Climate control › 39.15.33 Operating unit/cable — Series 690 (models 6**) · Series 901 (models 6**) · Series 902 (models 6**) · Series 903 (models 6**) · Series 904 (models 6**) · Series 905 (models 6**)

AR83.25-D-1124A

Remove and install air conditioning pushbutton control module

3.9.99

MODELS 901.6, 902.6, 903.6, 904.6, 905.6
with CODE (H25) Automatic heater control "Heatmatic"
with CODE (HH9) Automatic air conditioning "Tempmatic"

MODEL 690.6 with CODE (HH9) Automatic air conditioning "Tempmatic"

Remove and install air conditioning pushbutton control module

D83.20-1101-11

1 Air conditioning pushbutton control module

2 Cable

3 Cable

4 Connector

5 Connector

6 Screw

7 Bracket

Remove/install

1

Disconnect ground lead of battery

2.1

Remove stowage compartment below pen holder

Except code J19/J05, tachograph

2.2

Remove tachograph

With code J19/J05, tachograph

AR54.30-D-0001A

3

Remove cover on center part of instrument panel

AR68.10-D-1190A

4

Unscrew screws (6)

5

Identify cables (2 and 3) and remove from the air conditioning pushbutton control module (1)

Installation: The cable for the lower adjusting lever must be attached to the front adjusting knurl of the air conditioning pushbutton control module

6

Remove plugs (4 and 5)

7

Unscrew bracket (7) on both sides

Only if the air conditioning pushbutton control module is replaced

8

Install in the reverse order

9

Set time on instrument cluster

Except code J19/J05, tachograph

10

Set time on timer for auxiliary heater

With code H12, hot-water auxiliary heater or code H86, timer for auxiliary heater

11

Code radio if necessary

Referenced documents