AR82.85-L-7472VA | Remove and install operating and display system with control module | 16.2.12 |
MODEL 414.700
with CODE (EN3) Auto pilot system with GSM interface, large display
with CODE (EN4) Auto pilot system with TMC interface, large display
L82.85-0002-06
1 Removal tools (2 ea.)
A40/3 COMMAND operating, display and
control module
| Remove/install | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
1 | Disconnect ground cable of battery | ||
| Notes on battery | All types. | |
2 | Insert removal plates (1) with flattened grip ring upward (arrow) into recesses until they catch audibly | | |
3 | Pull the COMAND operating, display and control module (A40/3) out of the center console | ||
4 | Detach electrical plug sockets on the back of the COMAND operating, display and control module (A40/3) | ||
5 | Detach fiber optical cable coupling (D2B) | Fiber optic cable D2B: Do not buckle or stretch. | |
Install cover caps on fiber optic cable connector and equipment connection. Refer to: | |||
Cover optical waveguide | |||
6 | Press into one of the release holes with a small pin or screwdriver and release the removal plates (1) | ||
7 | Install in the reverse order | ||
8 | Read diagnostic trouble code memory and erase | Stored faults which may be caused by disconnecting cables or by simulation during removal and installation or test operations, must be processed and erased in the fault memories after completing the work. | |
Refer to: | |||
STAR DIAGNOSIS. |
Commercially available tools