P82.62-2154-09
Shown on model 203.0 |
1 | Wirings, center | A2/71 | Amplifier module 1, window antenna | X1/22 | Antenna module supply connector | ||
2 | Wirings, left | X1/19 | AM/FM antenna module connector | ||||
3 | Bracket | X1/20 | Intermediate frequency antenna module connector |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1.1 | Detach headliner and place down to front | Model 203.0, 209.3 | |
Model 203.0 | |||
Model 209.3 | |||
1.2 | Remove rear window | Model 203.7 | |
2 | Remove AM/FM antenna module connector (X1/19) from bracket (3) and disconnect | Model 203.0, 209.3 | |
3 | Remove intermediate frequency antenna module connector (X1/20) from bracket (3) and disconnect | Model 203.0, 209.3 | |
4 | Remove antenna module supply connector (X1/22) from bracket (3) and disconnect | Model 203.0, 209.3 | |
5 | Unclip center line guides (1) and remove line | ||
6 | Unclip left line guides (2) and remove line | ||
7 | Remove antenna amplifier module sealing rails |
| |
Installation: If no sealing rails have been installed at the vehicle, these must be retrofitted. | |||
Bonding agent Sika-Primer 206 G+P | |||
8 | Heat up amplifier module 1, window antenna (A2/71) and detach from the rear window using an assembly wedge | ||
| 000 588 00 84 00 Heat gun | ||
| |||
Installation: Replace amplifier module 1, window antenna (A2/71). | |||
Installation: When gluing on the amplifier module 1, window antenna (A2/71) ensure that, after removing the protective foil, this is immediately placed onto the rear window and pressed on for approx. 5 s. | |||
Mounting wedge | |||
9 | Remove adhesive residues from rear window | Installation: Treat bonding surface on rear window with activator or bonding agent. | |
Bonding agent Sika-Primer 206 G+P | |||
Sika activator | |||
10 | Install in the reverse order |
110 589 03 59 00
Mounting wedge