AR82.61-P-0100A | Remove/install CD drive in the Audio 50 APS | 22.7.08 |
MODEL 171.4 up to 2.3.08
except CODE (809) Model year 2009
with CODE (525) MB Audio 50 APS radio
After expiration of 24-month manufacturer's warranty for the radio and navigation unit
MODEL 211.0 /2 /6 up to 1.6.08
except CODE (809) Model year 2009
with CODE (525) MB Audio 50 APS radio
After expiration of 24-month manufacturer's warranty for the radio and navigation unit
MODEL 219.3 up to 2.3.08
except CODE (809) Model year 2009
with CODE (525) MB Audio 50 APS radio
After 24-month manufacturer's warranty for the radio and navigation unit has expired
P82.61-3657-09
Shown on model 211
1 CD drive
2 Screw
3 Housing upper section
A2/56 Radio and navigation unit
(model 171.4)
Radio control panel and navigation unit
(model 211, 219.3)
4 Housing lower section
5 Electrical connector
6 Lock
| Remove/install | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| The following fault messages require the CD drive (1) to be replaced: CD/DVD cannot be ejected General CD/DVD read error | ||
1 | Remove radio and navigation unit (A2/56) or radio control panel and navigation unit (A2/56) and place on an electrostatic discharge (ESD) workstation | Otherwise damage may occur to the electronics in the CD-drive (1) or the radio and navigation unit (A2/56) or the radio control panel and navigation unit (A2/56). ESD protection | |
Model 171.4 | |||
Model 211 | |||
Model 219.3 | |||
2 | Remove safety film attached to side of radio and navigation unit (A2/56) or radio control panel and navigation unit (A2/56) | ||
3 | Remove bolts (2) | ||
4 | Swivel housing upper section (3) upwards until the electrical connector (5) is accessible | Installation: Ensure that upper section of housing (3) is seated correctly on lower section of housing (4). | |
5 | Separate electrical connector (5) | Avoid contacting the conductor tracks on the PCB as otherwise damage may occur to the electronics in the CD drive (1). | |
6 | Detach upper section of housing (3) from lower section of housing (4) | ||
7 | Unlock locks (6) by spreading upper section of housing (3) and remove CD drive (1) from upper section of housing (3) | Installation: Ensure that CD drive (1) is seated correctly on upper section of housing (3) (arrows) and in locks (6). | |
8 | Install in the reverse order | ||
9 | Check navigation function | Start navigation, enter destination and start route guidance. | |
10 | Check playback function of an audio CD |