Remove/install radio

AR82.60-P-7502T

22.7.08

MODEL 211.0 /2 /6
with CODE (510) Audio 20 with CD changer
with CODE (511) Audio 50 APS with DVD changer
with CODE (521) MB Audio 50 radio USA (without navigation)
with CODE (523) MB Audio 20 radio
with CODE (525) MB Audio 50 APS radio

P82.60-6949-04

1 Bolts

A2 Radio
(with code (510) Audio 20 with CD changer
or with code (523) MB Audio 20 radio)

A2/56 Radio control panel and navigation unit
or with code (511) Audio 50 APS with DVD changer
or with code (521) MB Audio 50 radio USA (without navigation)
or with code (525) MB Audio 50 APS radio)

 	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Transfer basic data of radio (A2) or radio control panel and navigation unit (A2/56) to STAR DIAGNOSIS	When replacing radio (A2) or radio control panel and navigation unit (A2/56).  Installation: Transfer basic data from STAR DIAGNOSIS to radio (A2) or radio control panel and navigation unit (A2/56).
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
2.1	Remove center stowage compartment and place to one side with electrical lines still connected	Vehicles up to 1.6.08 without code (809) Model year 2009 without code (819) CD changer	AR68.10-P-1620T
2.2	Remove holder with CD changer and place to one side with electrical lines still connected	Vehicles up to 1.6.08 without code (809) Model year 2009 with code (819) CD changer	AR82.64-P-7508T
2.3	Remove upper control panel control unit holder and place to one side with electrical lines still connected	Vehicles as of 2.6.08 Vehicles with code (809) Model year 2009	AR54.21-P-1262TY
3	Unscrew bolts (1) counterclockwise as far as to the stop
4	Pull radio (A2) or radio control panel and navigation unit (A2/56) out of center console until the fiber optic cable connector and the electrical connectors at the rear of the radio (A2) or the radio control panel and navigation unit (A2/56) are accessible	 Depending on vehicle configuration.
5	Disconnect fiber optic cable connector and the electrical connectors on the rear of the radio (A2) or the radio control panel and navigation unit (A2/56)	 To avoid damaging the fiber optic cable, do not kink fiber optic cable, route over sharp edges or bend in radii smaller than 25 mm.
6	Cover fiber optic cable		AR82.95-P-0005-01A
7	Install in the reverse order

เอกสารที่อ้างถึง