ar8235s6010p

Remove/install washer fluid reservoir fill level sensor

ประเภท ar · หัวข้อ 82.35 · เวอร์ชัน 0100 · 2017-07-04

ใช้กับ: Model 470, 471

ไม่มีใน “th” แสดงเป็น อังกฤษ

ตำแหน่ง

กลุ่มฟังก์ชัน 3 Body › 82 Electrical system, body › 82.35 Windshield washing system — ซีรีส์ 470 · ซีรีส์ 471

EinPAS 36 Visibility › 36.30 Wiping/washing › 36.30.12 Sensor/switch/wiring harness — ซีรีส์ 470 · ซีรีส์ 471

AR82.35-S-6010P

Remove/install washer fluid reservoir fill level sensor

21.06.2017

Model

470, 471

Remove/install washer fluid reservoir fill level sensor

Shown on model 470 except code F2F (heated washer fluid nozzles)

1

Washer fluid reservoir fill level sensor

2

Electrical connector

3

Washer fluid reservoir

4

Seal

S82.35-4540-05

Danger

Risk of fire and explosion caused by ignition of window washing fluid or antifreeze and their vapors. Risk of poisoning caused by swallowing window washing fluid or antifreeze or inhaling their vapors. Risk of injury or physical irritations caused by contact of window washing fluid or antifreeze with eyes, mucous membranes or skin.

Wear protective clothing and tight-fitting safety glasses. No open flames, fire or ignition sources. Avoid contact with eyes, mucous membranes and skin. When working with window washing fluids or antifreeze, do not eat, drink, or smoke. Do not inhale vapors and ensure sufficient ventilation in the working area. Store window washing fluid and antifreeze leakfree in safely closed original containers and out of the reach of children.

AS82.35-Z-0001-01A

Remove

1

Release right front fender liner in rear area until the washer fluid reservoir fill level sensor (1) is accessible

AR88.10-S-1301P

2

Disconnect electrical connector (2)

3

Pry out washer fluid reservoir fill level sensor (1) from the washer fluid reservoir (3) and seal (4)

Drain washer fluid into a suitable container.

Long wedge

*115589035900

Install

4

Check seal (4) for damage and correct seating in the washer fluid reservoir (3)

If seal (4) is damaged.

Install new seal (4).

If seal (4) is not properly seated in the washer fluid reservoir (3).

Correctly position seal (4).

5

Install washer fluid reservoir fill level sensor (1) in the seal (4) and the washer fluid reservoir (3)

6

Connect electrical connector (2)

7

Fill washer fluid reservoir (3)

Check

8

Perform function check of windshield washer system

AP82.30-S-8252P

9

Carry out a leak test on the washer fluid reservoir fill level sensor (1) and washer fluid reservoir (3)

10

Fasten the right front fender liner in the rear area

AR88.10-S-1301P

Remove/install washer fluid reservoir fill level sensor

115 589 03 59 00

Long wedge

เอกสารที่อ้างถึง