Shown on right rear door (3) |
1 | Power window |
2 | Side window(s) |
3 | Rear door |
4 | Cup suction tool |
5 | Electrical connector |
6 | Screw |
7 | Bolts |
8 | Nut |
9 | Bolts |
10 | Rear power window motor |
S72.12-4513-06
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Caution | Risk of injury from contusions to hands if window glass is not secured | Secure window to prevent it from falling down. | |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Remove side window (2) of rear door (3) from power window (1) | ||
2 | Completely push released side window (2) upward by hand and secure against falling down with cup suction tool (4) | Commercially available devices/tools | |
3 | Disconnect electrical connection (5) | ||
4 | Loosen bolt (6); do not unscrew completely | ||
5 | Remove bolts (7) | ||
6 | Unscrew nuts (8, arrow) | ||
7 | Remove power window (1) from rear door (2) | ||
8 | Unscrew bolts (9) and remove rear power window motor (10) from power window (1) | When replacing power window (1). | |
9 | Install in the reverse order |