Model | 374.502/523/551 with body 374.860 |
with code F04 (L-cab) | |
Model | 374.602/651 with body 374.870 |
with code F04 (L-cab) | |
Model | 374.607/691/695 with body 944.890 |
with code F04 (L-cab) | |
Model | 375.1 with body 375.830/850 |
with code F04 (L-cab) | |
Model | 375.3 with body 375.810/820 |
with code F04 (L-cab) | |
Model | 375.4 with body 375.860 |
with code F04 (L-cab) | |
Model | 940, 942, 943, 944 with body 944.890 |
with code F04 (L-cab) | |
Model | 944 with body 944.899 |
with code F04 (L-cab) | |
Model | 950.5/6, 952.5/6, 953.6, 954.5 with body 940.890/899 |
with code F04 (L-cab) | |
Model | 970, 972, 974, 975, 976 with body 972.890/899 |
with code F04 (L-cab) |
1 | Seal |
2 | Window |
3 | Screwdriver |
4 | Cup suction tool |
W67.30-0002-06
W67.30-0003-09
1 | Seal | 6 | Window imprint | A | Overlap area of pulling cord | ||
2 | Window | 7 | Side wall | ||||
5 | Pulling cord | 8 | Cover |
| Remove | ||
1 | Install cup suction tool (4) on inside of window (2) | ||
2 | Pry sealing rubber lip (1) from vehicle interior over edge of window frame toward outside with screwdriver (3) | Hold window (2) with cup suction tool (4). | |
3 | Remove window (2) with cup suction tool (4) | ||
4 | Remove seal (1) from window (2) | Check seal (1) and window (2) for reusability. | |
| Install | ||
5 | Install seal (1) on edge of window (2) | Install with angled long sealing lip (1) pointing toward vehicle interior. The window imprint (6) should be located at the bottom of the window (2) after installation. | |
6 | Insert pull-in cord (5) all the way around the window (2) below the long rubber lip on the seal (1) | The overlap area of the pull-in cord (A) should be approx. 10 cm long. | |
7 | Coat angled side of seal (1) with lubricant | Lubricant | |
8 | Press window (2) uniformly against window frame from outside wall with aid of helper with rubber seal (1) installed | Allow free ends of pull-in cord (5) to hang down in vehicle interior. | |
9 | Uniformly pull free ends of pull-n cord (5) into vehicle interior | The long sealing lip of the seal (1) should lay around the paneling (8) all the way around. | |
10 | Check seat of seal (1) and window (2) on inside and outside and correct if necessary | ||
11 | Remove lubricant residues from window (2) and seal (1) |