P54.10-2471-07
Shown on vehicle up to 31.5.06 |
1 | Ground cable | 2 | Nut | G1 | Battery |
| Remove/install | ||
Danger ! | Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fires, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. | |
| Notes on battery | ||
1 | Switch off the ignition and remove the transmitter key from the EIS control unit | On vehicles with code (889) KEYLESS-GO: Press KEYLESS-GO start/stop button repeatedly until ignition is switched off. Remove the transmitter key from the vehicle and store at a location that is beyond the transmitter range (at least 2 m). | |
2 | Remove trunk floor covering from trunk | ||
3 | Remove spare tire cover or spare tire well trim from the luggage compartment | Depending on vehicle equipment. | |
4 | Disconnect electrical connector from battery sensor | MODEL 219.3 as of 6/1/06 | |
5 | Loosen nut (2) and remove ground line (1) from battery (G1) | Nut, battery line to negative terminal/positive terminal | |
6 | Install in the reverse order | ||
7 | Perform basic programming | Perform basic programming |