Model | 463.236/248 |
up to model year 2015 | |
with code 979 (Special protection MB Guard) | |
with code E26 (Auxiliary battery) | |
with code ZS6 (Special protection version FB6) | |
Model | 463.236/248 |
up to model year 2015 | |
with code 979 (Special protection MB Guard) | |
with code E26 (Auxiliary battery) | |
with code ZS7 (Special protection version FB7) | |
Model | 463.242 |
up to model year 2015 | |
with code E26 (Auxiliary battery) |
A | Cup holder |
B | Battery box cover |
P68.20-2740-02
G1 | Battery |
P54.10-2095-11
Shown in rear legroom |
1 | Power supply unit enabled |
2 | Power supply unit interrupted |
3 | Main battery switch |
P54.10-2157-11
G1/3 | Additional battery |
W10/4 | Additional battery ground connection |
P54.10-2156-06
| Remove/install | ||
Danger | Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fires, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. | |
1 | Activate service mode in TELEAID (emergency call system) (Telematic Alarm Identification on Demand) |
| |
Information on Tele Aid emergency call system | Model 463.248 up to 4/1/07 | ||
2 | Disconnect battery main switch (3) | For working on the on-board electronics, the ground line of battery (G1) need not be removed; only the battery main switch (3) must be disconnected. | |
The battery main switch (3) is located next to the battery (G1) under a cover in the rear footwell. | |||
3 | Remove cup holder (A) | Only with front and rear cupholder. | |
4 | Remove battery box cover (B) | ||
5 | Detach ground cable at battery (G1) | ||
Topical note | Notes on battery | ||
The ground line of the additional battery (G1/3) in the right rear stowage box only needs to be disconnected if consumers are connected to this additional battery. | |||
Battery (G1) in the rear footwell. | |||
6 | Install in the reverse order | ||
7 | Deactivate service mode in Tele-Aid emergency call system |
| |
Information on Tele Aid emergency call system | Model 463.248 up to 4/1/07 | ||
8 | Perform basic programming |
| |
9 | Read out fault memory and erase | ||
| Model 463.236/248 | ||
Diagnostic system: Stored faults caused by installation or testing work, disconnected lines or simulation, must be processed and deleted in the fault memories after completing the work. |