P47.70-A029-09
1 | Diagnostic unit case | 5 | Diagnostic system | |
2 | Diagnostic unit | 6 | Power cable | |
3 | Adapter cable | 7 | 12 V supply cable | |
4 | Vehicle Communication Interface | A100 | High-voltage battery module |
Danger | Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death due to voltage U >= 30 V AC and U >= 60 V DC. | No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers. | |
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | Notes on battery | ||
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Notes on safety-relevant components | |||
| Check | ||
1 | Connect the diagnostic unit (2) to the adapter cable (3) on the high-voltage battery module (A100). | ||
| 000 586 00 99 00 Battery diagnostic unit | ||
Adapter cable | |||
2 | Attach the ground strap of the adapter cable (3) to the housing of the high-voltage battery module (A100). | ||
3 | Connect power supply to diagnostic unit (2). | Use mains cable (6) or 12 V supply cable (7). | |
4 | Connect diagnostic system (5) with Vehicle Communication Interface (4) to diagnostic unit (2). | When using XENTRY Kit, XENTRY Connect must be connected to the external power supply. | |
5 | Switch on switch 1 (POWER) on the diagnostic unit (2). | ||
6 | Switch off switch 2 on the diagnostic unit (2). | ||
7 | Switch on switch 3 (circuit 15) on the diagnostic unit (2). | ||
8 | Start vehicle diagnosis system (5). | ||
9 | Select the diagnosis through the appropriate path. | | |
The fault memory may not be deleted when the high-voltage battery has been removed. | |||
10 | Remove the ground strap of the adapter cable (3) from the housing of the high-voltage battery module (A100). | ||
11 | Disconnect the adapter cable (3) from the high-voltage battery module (A100) and diagnostic unit (2). | ||
12 | Disconnect diagnostic unit (2) and diagnostic system (5) with Vehicle Communication Interface (4). |
222 589 04 63 00
Adapter cable