S46.20-4526-09
1 | Steering gear | 5 | Cross strut | |
2 | Universal joint | 6 | Screw | |
3 | Screw | 7 | Screw | |
4 | Electrical connector | 8 | Screw |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Remove/install | ||
1 | Move steering gear (1) to center position. | ||
Retainer device | |||
2 | Detach lower engine compartment paneling | ||
3 | Remove left transverse control arm from front axle carrier | ||
Do not remove transverse control arm from steering knuckle. | |||
4 | Remove ball heads of steering gear (1) from steering knuckles | ||
5 | Detach universal joint (2) from steering gear (1) | Remove screw (3) to do this. | |
Bolt, universal joint to steering gear | |||
6 | Disconnect electrical connectors (4) | ||
7 | Remove cross strut (5) | To do so, remove bolts (6) and (7). | |
Screw, cross strut to front axle carrier/integral carrier | |||
Nut/screw, steering gear to integral carrier or integral carrier diagonal strut | |||
8 | Remove steering gear (1) | To do so, remove screws (8) and remove steering gear (1). | |
Nut/screw, steering gear to integral carrier or integral carrier diagonal strut | |||
9 | Install in the reverse order | ||
10 | Enter new steering number of steering gear (1) in on-line vehicle data card via vehicle documentation (VeDoc) | Only when replacing the steering gear (1). | |
Redocumentation is absolutely essential. | |||
11 | Run teach-in process on steering gear (1) using diagnostic system | Only when replacing the steering gear (1). | |
| Connect STAR DIAGNOSIS and read out fault memory |
129 589 01 21 00
Retainer device