AR46.20-B-3015TA | Check and adjust center steering position on steering gear | 12.02.16 |
Steering gear 765.82 with Vehicle 958.2, 958.4
Steering gear 765.83 with Vehicle 958.0
W46.20-1051-06
1 Steering shaft
2 Screw
3 Nut
4 Primary shaft
5 Steering gear
6 Rotating retainer
7 Steering rod
A arrow Marking (primary shaft)
B arrow Marking (steering gear)
Danger! | Risk of injury by trapping or crushing when dumping the cab | During dumping there shouldn't be people in the cab dumping area. Always tilt the cab to its final position and lock. | |
Danger! | Risk of death caused by vehicle slippage or tumbling during lifting | Lift the vehicle through the points recommended by the manufacturer. | |
| Check | ||
| Instructions for tilting cab | ||
| Information on self-blocking nuts and bolts | ||
1 | Check the smooth operation of steering knuckle and steering joints | ||
2 | Check tire pressure and calibrate them if necessary | ||
3 | Adjust steering stud ensuring the free movement of the tire | ||
4 | Position vehicle with the wheels of the front axle on the rotating retainer (6) | ||
5 | Check front axle convergence and place wheels in straight position | ||
6 | Tilt the cab | ||
7 | Check the marking position (arrows A and B) in the primary shaft (4) and in the steering gear (5) | The markings (arrows A and B) must be aligned. If necessary, adjust the central position of the steering gear direction (5). | |
Adjusting | |||
8 | Remove steering bar (7) in front axle steering lever | ||
9 | Tilt the cab back | ||
10 | Determine the number of steering wheel turns from the left stop to the right stop of the steering box | Veer the steering from one stop to another. | |
11 | Turn the steering wheel back to the half number of specified turns | The center position of the steering gear is achieved. The marking (arrow A) in primary tree (4) and the marking (arrow B) in the steering box must be aligned. Otherwise, the marking (arrow A) must be set in the markup (arrow B). | |
12 | Tilt the cab | ||
13 | Install steering bar (7) in front axle steering lever | Adjust the steering bar length (7) in such a way that it can be installed in the steering lever without tension. The straight position of the front wheels and the center position of the steering gear should not be changed. | |
| Check | ||
14 | Tilt the cab back | ||
15 | Check the steering wheel centering | If necessary, remove the steering wheel and install it again in straight position: Remove and install the steering wheel. | |
16 | Lift the vehicle and remove the rotating retainer (6) | ||
17 | Lower the vehicle | ||
18 | Perform a test run | Check the general steering behavior. |