Remove/install brake booster vacuum sensor

AR43.10-P-0352EH

Remove/install brake booster vacuum sensor

27.04.2012

MODEL

212.095/195 with ENGINE 276.9

MODEL

212.098/298 with ENGINE 651.9

1

Strut

2

Nut

3

Expansion rivet

4

Seal plug

A7/7

BAS brake booster

B64/1

Brake vacuum sensor

 

Remove/install



Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

1

Switch off ignition

2

Operate brake several times

 In order to reduce the given vacuum in the BAS brake booster (A7/7).

3

Open engine hood and raise to vertical position

AR88.40-P-1000EW

4

Remove expansion rivet (3)

5

Unscrew nut (2) and remove strut (1) to the front

 Nut, strut to suspension strut tower

BA62.30-P-1006-02G

6

Pry brake vacuum sensor (B64/1) out of BAS brake booster (A7/7)

 Installation: Check seal plug (4) and brake vacuum sensor (B64/1) are correctly seated.

 Check seal plug (4) for signs of damage, replace if necessary.

7

Release and detach electrical connector from brake vacuum sensor (B641)

8

Remove brake vacuum sensor (B64/1)

9

Install in the reverse order



Check

10

Start engine

 Operate brake several times.

11

Turn off engine

12

Check leaktightness of brake vacuum sensor (B64/1)

 Air flow noises must not be audible at the BAS brake booster (A7/7).

 Front end with front reinforcement

Number

Designation

MODEL 212

BA62.30-P-1006-02G

Nut, strut to suspension strut tower

Nm

30