Shown on model 470, on left side of vehicle |
1 | Electric line |
2 | Electrical connector |
3 | Electrical connector |
4 | Bracket |
S42.30-4524-06
Shown on model 470, on left side of vehicle |
1 | Electric line |
5 | Screw |
6 | Rpm sensor |
7 | O-ring |
S42.30-4525-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Switch off ignition. | ||
2 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
3 | Unhook electrical line (1) from holders (arrows). | ||
4 | Disconnect electrical connection (2). | ||
5 | Release electrical connector (3) and remove upward from holder (4). | ||
6 | Remove rpm sensor (6). | Remove screw (5) to do this. | |
| Clean | ||
7 | Remove grease from rpm sensor (6) using lint-free rag. | If rpm sensor (6) is reused. | |
| Check | ||
8 | Check O-ring (7) for damage. | If there is a problem: | |
| |||
Replace rpm sensor(6). | |||
| Install | ||
9 | Coat rpm sensor (6) with grease. | ABS sensor grease | |
10 | Position rpm sensor (6) in wheel bearing housing and screw in screw (5). | ||
Note on calculation of tightening torque when using insertion or socket tools with various effective lengths | |||
Commercially available devices/tools | |||
Screw/bolt, front axle rpm sensor to wheel bearing housing | |||
11 | Slide electrical connector (3) from above onto holder (4). | Electrical connector (3) must lock into place. | |
12 | Hook electric line (1) into holders (arrows). | ||
13 | Connect electrical connector (2). | ||
14 | Lower vehicle. | ||
15 | Read out and delete fault memory. | ||
| Connect/disconnect diagnostic unit |