1 | Boot |
2 | Outer radial shaft sealing ring |
3 | Bearing bracket |
4 | Nut |
5 | Inner radial shaft sealing ring |
6 | Brake shoe |
7 | Inner return spring |
8 | Outer return spring |
9 | Screw |
10 | Brake camshaft |
11 | Brake spring hook |
A | Marking |
W42.15-1022-06
Danger ! | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
| Notes on self-locking nuts and bolts | ||
| Remove/install | ||
1 | Remove wheel hub |
| |
Front axle without code KR83 (Tire pressure control system) | |||
2 | Remove diaphragm brake cylinder | ||
3 | Remove automatic linkage adjuster |
| |
Front axle without brake wear sensor | |||
4 | Using a suitable brake spring hook (11), first unhook outer retracting spring (8) and then inner retracting spring (7) | ||
5 | Lift brake shoes (6) off brake camshaft (10) and fold to one side | ||
6 | Remove rubber boot (1) and pull out brake camshaft (10) | Installation: Grease the bearings and splines of the brake camshaft (10). | |
Long-life grease | |||
7 | Detach bearing bracket (3) from brake carrier | Installation: Attach the bearing bracket (3) using new nuts (4). | |
Nut, brake camshaft bearing bracket to brake carrier | |||
8 | Remove outer radial shaft sealing ring (2) and inner radial shaft sealing ring (5) | ||
Installation: Grease the sealing lips of the inner radial shaft sealing ring (5) and the outer radial shaft sealing ring (2). | |||
Long-life grease | |||
Drift | |||
9 | Install in the reverse order | ||
10 | Check function and effectiveness of service brake |
387 589 06 15 00
Drift