P42.10-2547-07
1 Floating caliper
3 Brake disk
2 Security bolt
Modification notes
29.11.11 | Long-life grease repair materials replaced by hot-grease paste | Operation step 3 |
| Remove/install | ||
| Notes on repairs to brake system | ||
| Notes on self-locking nuts and bolts | ||
1 | Release parking brake | Only if removing brake disk (3) at the rear axle. | |
2 | Detach floating caliper carrier from upright or wheel carrier | Remove/install floating brake caliper of front axle. | |
Remove/install floating brake caliper of rear axle. | |||
3 | Remove locking bolt (2) and remove brake disk (3) | When removing brake disk (3) on rear axle: If parking brake drums are run in, turn back the adjusting mechanism of the parking brake beforehand. Otherwise the parking brake shoes may be damaged: | |
See Adjust parking brake. | |||
Installation: Always replace the brake disks (3) in pairs. Apply light coating of grease to interference fit of brake disk (3). Replace locking bolt (2). | |||
Adjusting parking brake. | |||
| |||
Hot lubricating paste | |||
| Checking | ||
4 | Check brake disk (3) | ||
| Inspect condition of brake disks | ||
5 | Check parking brake shoes | After removing the brake disk (3) from the rear axle. Check lining thickness and condition, if necessary: | |
Replace parking brake shoe. | |||
6 | Install in the reverse order |
Front axle brake disks
Repair materials
Number | Designation | Order number |
BR00.45-Z-1005-06A | Paste, hot lubrication 1 kg, DB supply specification 6879.20 | A 000 989 76 51 |