Test values for distance and comparison measurements on rear axle
Number | Designation | Model 212 | Model 218 | ||
BE40.30-P-1001-05H | Dimension | H1 | mm | 1785 (2) | 1785 (2) |
H2 | mm | 2248 (2) | 2248 (2) | ||
H3 | mm | 1070 (2) | 1070 (2) | ||
H4 | mm | 791 (2) | 791 (2) | ||
H5 | mm | 1076 (2) | 1076 (2) | ||
See picture | |||||
170 589 00 63 00
168 589 07 63 00
124 589 01 19 00
124 589 02 19 00
Mount
Telescopic measuring rod
Telescopic measuring rod
Set of measurement fixtures
124 589 08 63 00
Connecting pieces
The measuring set is designed in such a way, that the measuring bolts, according to the measuring points at the vehicle, can be screwed together out of mounting bolts, extensions and measuring tips/bolts.
The configuration of the measuring bolts is shown in the table, where the digits in the column headed "Measuring bolt configuration" are the special tool end numbers.
For example: 02/07/10 = 168 589 07 63 02 (support stud)
168 589 07 63 07 (extension)
168 589 07 63 10 (measuring tip)
Clearance | Measuring bolt configuration | Telescopic measuring rod |
H1 | 02/06/09/05/socket wrench bit | 124 589 02 19 00 |
H2 | 02/09/08/05/socket wrench bit | 124 589 02 19 00 |
H3 | Left: 02/06/09/05/socket Right: 02/09/07/05/socket | 124 589 02 19 00 |
H4 | 02/07/05/socket wrench bit | 124 589 01 19 00 |
H5 | 02/06/09/05/socket wrench bit | 124 589 02 19 00 |
P40.30-2305-11
1 Measure distance dimension (H1) from check point (K) to center of Torx bolt head of front mount of rear axle carrier. Measure on the left and right side in each case.
If necessary, unscrew and screw in Torx bolts and check for deformation.
Shown on model 204.0
P40.30-2348-11
2 Measure distance dimension (H2) from check point (K) to center of Torx bolt head of rear mount of rear axle carrier. Measure on the left and right side in each case.
If necessary, unscrew and screw in Torx bolts and check for deformation.
P40.30-2349-11
3 Measure distance dimension (H3) diagonally between the centering point of the Torx bolt heads to the front and rear bearing of the rear axle carrier.
P40.30-2308-11
4 Measure distance dimension (H4) from the centering point of the Torx bolt heads between the rear bearings of the rear axle carrier.
Shown on model 204.0
P40.30-2309-11
5 Measure distance dimension (H5) from the centering point of the Torx bolt heads between the front bearings of the rear axle carrier.
Shown on model 204.0