1 | Lift bellows |
2 | Cross member (lower lift bellows) |
3 | Screw |
4 | Bow |
5 | Nuts (upper bracket) |
6 | Cross member (upper lift bellows) |
7 | Nuts (lower bracket) |
8 | Compressed-air connector |
W35.50-1108-06
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Topical note | Notes on self-locking nuts and bolts | ||
Notes on compressed air connection systems | |||
| Remove | ||
1 | Secure vehicle to prevent it moving away. | ||
2 | Switch on ignition. | ||
3 | Fully lower trailing axle. | ||
4 | Switch off ignition. | ||
5 | Remove compressed air connector (8). | ||
6 | Remove bracket (4). | ||
7 | Remove screw (3). | ||
8 | Remove lift bellows (1) with crossmember (2, 6). | ||
| Install | ||
9 | Clean contact surface of crossmember (2). | ||
10 | Insert lift bellows (1) with crossmember (2, 6). | The compressed air connection must point forwards. | |
11 | Install screw (3). | Screw/bolt, lower lift bellows cross member to bracket | |
12 | Install bracket (4). | ||
13 | Attach compressed air connector (8). | ||
14 | Switch on ignition. | ||
15 | Fully raise trailing axle. | ||
16 | Switch off ignition. | ||
17 | Check compressed air connection (8) for leak tightness. | Use commercially available leak detector spray. |