1 | Lift bellows |
2 | Crossmember (lower lift bellows) |
3 | Screw |
4 | Bow |
5 | Nuts (upper bracket) |
6 | Crossmember (upper lift bellows) |
7 | Nuts (lower bracket) |
8 | Compressed air connector |
W35.50-1108-06
| Remove | ||
1 | Secure vehicle against rolling | ||
2 | Switch on ignition | ||
3 | Fully lower additional axle | ||
4 | Switch off ignition | ||
5 | Remove nuts (5) and detach bracket (4) from crossmember (6) | Do not change the installation positions of the nuts (7). | |
| Install | ||
6 | Install nuts (7) on bracket (4) | Only if the bracket (4) has been replaced. | |
7.1 | Install bracket (4) in crossmember (6) and install nuts (5) | If the bracket (4) has not been replaced. | |
Do not change the installation positions of the nuts (7). | |||
Nut, top bracket to lift bellows crossmember | |||
7.2 | Install bracket (4) in crossmember (6) and fit nuts (5) loosely | If the bracket (4) has been replaced. | |
8 | Adjust bracket (4) | Only if the bracket (4) has been replaced. | |
Distance "B" between bracket and axle at bottom (trailing axle completely lowered) | |||
Thread protrusion "A" at top of bracket | |||
Nut, top bracket to lift bellows crossmember | |||
9 | Switch on ignition | ||
10 | Fully raise additional axle | ||
11 | Switch off ignition |