ar3530d481502b

Measuring basic dimension on differential

ประเภท ar · หัวข้อ 35.30 · เวอร์ชัน 0104 · 2001-07-24

ใช้กับ: REAR AXLE 741.130 /131 /404 /405 /408 /436 /438 /439 /52 /530 /540 /55 with CODE (A71) Rear axle with differential lock REAR AXLE 741.407 with CODE (A71) Rear axle with differential lock with CODE (AC7) Rear axle ratio i = 3.272 with CODE (AE1) Rear axle ratio i = 2.923 REAR AXLE 741.130 /408 in MODEL 690.6 with CODE (A71) Rear axle with differential lock

ไม่มีใน “th” แสดงเป็น อังกฤษ

ตำแหน่ง

กลุ่มฟังก์ชัน 2 Chassis › 35 Rear axle › 35.30 Final drive, drive shafts — ซีรีส์ 690 (รุ่น 6**)

EinPAS 17 Drivetrain/axle › 17.51 Rear axle › 17.51.65 Rear axle differential/axle through-drive — ซีรีส์ 690 (รุ่น 6**)

ใช้กับเครื่องยนต์/เกียร์ด้วย: 741 130, 741 131, 741 404, 741 405, 741 407, 741 408, 741 436, 741 438, 741 439, 741 52*, 741 530, 741 540, 741 55*

AR35.30-D-4815-02B

Measuring basic dimension on differential

Measuring basic dimension on differential
Measuring basic dimension on differential

601 589 00 21 00

Adjustment device

460 589 03 63 00

Ring

Measuring basic dimension on differential

D35.30-0072-01

A Measuring internal dimension of axle housing

1 Push spacer ring () onto left-hand side of measuring device (02, ).

2 Install measuring device (02, ) in rear axle housing and measure gap using feeler gauge (a).

2 Determine internal dimension of housing and note measurement.
The internal dimension is calculated by adding the size of the special tool and the measurement for the gap.

Example: Special tool size 163.8 mm

Feeler gauge gap 1.1 mm

Internal housing dimension 164.9 mm

Measuring basic dimension on differential

D35.30-0073-01

B Measuring differential

1 Place differential on a level surface with one 5mm thick shim at the top and another at the bottom, and meaasure the overall height (arrows).

Example: Differential measured with shims 164.1 mm

Differential without shims 154.1 mm