1 | Tie rod |
2 | Eccentric disk |
3 | Rear axle carrier |
4 | Wheel carrier |
P35.20-2378-06
| Notes on threaded connections fastened using a tightening angle-based tightening process | ||
| Notes on self-locking nuts and bolts | ||
| Notes on handling, transport and storage of ceramic brake disks | ||
| Notes on handling, transport and storage of composite brake disks | ||
| Notes on repair work on suspension components | ||
| Remove/install | ||
1 | Remove rear axle. | ||
2 | Mark installation position of eccentric disk (2) | The toe-in is set at the factory using the eccentric disk (2). | |
3 | Remove level sensors with holders from tie rod (1) | If installed. | |
4 | Remove tie rod (1) from rear axle carrier (3) | Installation: Observe the marking on the eccentric disk (2). | |
Self-locking nut, tie rod to rear axle carrier | |||
Screwdriver bit | |||
5 | Detach tie rod (1) from wheel carrier (4) and remove | Bolt, tie rod to wheel carrier | |
Screwdriver bit | |||
| Check | ||
6 | Check tie rod (1) for condition and signs of damage | If there are problems | |
| |||
Replace tie rod (1). | |||
7 | Install in the reverse order | ||
8 | Perform wheel alignment check |
119 589 00 10 00
Screwdriver bit