W35.30-0002-06
1 Through-drive shaft
2 Threaded ring
3 Radial sealing ring with dust lip
4 Radial sealing ring without dust lip
5 Grooved ball bearing
6 Locking plate
7 Slotted nut
8 Drift
9 Claw-type wrench
10 Puller
| Disassemble | ||
1 | Remove through-drive shaft | ||
2 | Release slotted nut (7) and screw off | | |
3 | Remove locking plate (6) | ||
4 | Detach grooved ball bearing (5) from through-drive shaft (1) | | |
5 | Take off threaded ring (2) and remove radial sealing rings (3 and 4) | ||
| Assemble | ||
6 | Install radial sealing rings (3 and 4) | Coat radial sealing rings without outer surface lined with rubber with sealant. First install radial sealing ring (4, without dust lip) with lip to the threaded side, then radial sealing ring (3, with dust lip). Fill space between dust and sealing lip with grease. | |
| |||
7 | Mount threaded ring (2) onto through-drive shaft (1) | ||
8 | Slide grooved ball bearing (5) up to the end stop on the shaft of through-drive (1) | Before sliding on, heat up grooved ball bearing to approx. 80 °C. | |
9 | Slide new locking plate (6) onto through-drive shaft (1) | The lug of the locking plate must point towards the coupling flange. | |
10 | Tighten slotted nut (7) and secure | | |
| |||
11 | Install shaft of through-drive |
Differential assembly with through-drive
Number | Designation | Front axles 730.102/110 | ||
BA33.30-N-1012-06A | Slotted nut on through-drive shaft | M55x1.5 | Nm | 450 |
001 589 19 33 00
395 589 05 07 00
389 589 02 15 00
Puller
Drift
Claw-type wrench
Repair materials
Number | Designation | Order number |
BR00.45-Z-1015-01A | Loctite 5203 sealant | A 002 989 71 20 10 |
BR00.45-Z-1017-06A | MB multipurpose grease | A 001 989 34 51 11 |