1 | Brake wear sensor |
2 | Air suspension bellows carrier |
3 | Drag link |
4 | Compressed-air line |
5 | Nut |
6 | Nut |
7 | Cap |
8 | Front axle |
9 | Screw |
10 | Stabilizer link |
11 | Screw |
12 | Bearing bracket |
W33.10-1022-06
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
Notes on safety-relevant components | |||
| Remove/install | ||
1 | Remove wheels from axle concerned. | ||
After jacking up, leave the lifting device positioned at the front axle. | |||
2 | Remove drag link (3) from steering arm. | If necessary, remove cover cap (7). The drag link (3) loosens suddenly. | |
Installation: Replace nut (6). | |||
Nut to tie rod end and drag link end | |||
Puller | |||
3 | Remove left and right anti-lock braking system (ABS) rpm sensor. | ||
4 | Disconnect electrical connectors from brakepad wear sensor (1). | | |
5 | Remove compressed-air lines (4) from brake cylinders. | ||
"VOSS 232" compressed-air connector | |||
6 | Support front axle (8) with lifting device and secure against tilting. | ||
7 | Remove stabilizer link (10) from front axle, swivel downward and remove bearing brackets (12). | Stabilizer link and bearing bracket to front axle | |
8 | Remove front axle (8) from air suspension supports (2). | Installation: Replace bolts (9). | |
Air suspension bellows carrier to front axle | |||
Socket wrench bit | |||
9 | Lower front axle (8) and pull out from under vehicle. | ||
10 | Install in the reverse order. |
625 589 00 35 00
Puller
963 589 00 09 00
Socket wrench bit