Shown on front axle on vehicle without code R0Z (Wheel nut cap) |
1 | Wheel hub |
2 | Wheel nut |
3 | Wheel bolt |
4 | Disk wheel |
W40.10-1019-11
Danger | Risk of death caused by vehicle slipping or toppling off during lifting | Only lift vehicle at the lift support points specified by the vehicle manufacturer. | |
Topical note | Special instructions for lifting and supporting vehicle | ||
Topical note | Notes on lug bolts | ||
Notes on safety-relevant components | |||
| Remove | ||
1 | Secure vehicle to prevent it moving away. | ||
2 | Loosen wheel nuts (2) on wheels to be removed on an axle. | ||
3 | Lift vehicle at axle until the wheels can turn freely and jack up vehicle at vehicle frame. | ||
4 | Unscrew wheel nuts (2). | ||
5 | Remove wheel nut caps. | Only on vehicles with code R0Z (Wheel nut cap). | |
6 | Remove wheels. | ||
| Check | ||
7 | Check wheels for condition and damage. | If a tire is worn or damaged, or a disk wheel (4) is damaged, | |
| |||
replace tire or disk wheel (4). | |||
8 | Check wheel nuts (2) and wheel studs (3) for damage. | If a wheel stud (3) or wheel nut (2) is damaged, | |
| |||
replace wheel stud (3) or wheel nut (2). | |||
| Install | ||
9 | Clean contact surfaces of disk wheels (4) and wheel hubs (1). | ||
10 | Slide wheels onto wheel studs (3). | ||
11 | Slide on wheel nut caps. | Only on vehicles with code R0Z (Wheel nut cap). | |
12 | Screw wheel nuts (2) onto wheel studs (3) and lightly tighten evenly in a crosswise pattern. | ||
13 | Lower vehicle. | ||
14 | Tighten wheel nuts (2) evenly and in a crosswise pattern. | When handing the vehicle over to the customer or driver, point out that the wheel nuts (2) must be retightened to the specified tightening torque after a driving distance of 50 to 100 km. | |
Wheel nut, steel wheel to wheel flange | |||
Wheel nut, light alloy wheel to wheel flange |