Danger
| Risk of death caused by vehicle slipping or toppling off of the lifting platform.
| Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.
| AS00.00-Z-0010-01A
|
|
| Notes on repair work on suspension components
|
| AH00.00-P-0100-01A
|
| Remove/install
|
|
|
1
| Remove cover from right jack support point.
|
Model 447 with engine 654.9
with code CU1 (Aerodynamic underbody panelling)
with code ZG2 (Permanent all-wheel drive)
Model 447.### ## up to 048754 with engine 651
with code MX0 (BlueEFFICIENCY package)
with code ZG2 (Permanent all-wheel drive)
Model 447.8## ## as of 048755 with engine 651
with code MX0 (BlueEFFICIENCY package)
with code VQ1 (AVANTGARDE)
with code ZG2 (Permanent all-wheel drive)
| AR61.30-S-1001-04E
|
2
| Remove lower engine compartment paneling.
|
| AR61.20-S-1105E
|
3
| Remove the underfloor paneling on the right.
|
Model 447 with engine 654.9
with code CU1 (Aerodynamic underbody panelling)
with code ZG2 (Permanent all-wheel drive)
Model 447.### ## up to 048754 with engine 651
with code MX0 (BlueEFFICIENCY package)
with code ZG2 (Permanent all-wheel drive)
Model 447.8## ## as of 048755 with engine 651
with code MX0 (BlueEFFICIENCY package)
with code VQ1 (AVANTGARDE)
with code ZG2 (Permanent all-wheel drive)
| AR61.30-S-1001-01E
|
4
| Remove screws (2) and remove retaining frame (1) of right underfloor paneling.
| Model 447 with engine 654.9
with code CU1 (Aerodynamic underbody panelling)
with code ZG2 (Permanent all-wheel drive)
Model 447.### ## as of 048755 with engine 651
with code MX0 (BlueEFFICIENCY package)
with code VQ1 (AVANTGARDE)
with code ZG2 (Permanent all-wheel drive)
Model 447.### ## up to 048754 with engine 651
with code MX0 (BlueEFFICIENCY package)
with code ZG2 (Permanent all-wheel drive)
|
|
5
| Disconnect cable tie and remove electrical wiring harness (3) of auxiliary oil pump.
| Model 447 with code MJ8 (ECO start/stop function)
|
|
|
|
| Installation: Replace cable tie.
|
|
6
| Remove both torsion bar linkages from stabilizer (4).
|
| AR32.35-S-3328E
|
7
| Remove screws (5) and remove stabilizer (4).
| Nut/screw, stabilizer bar to integral carrier
| *BA32.35-N-1001-02K
|
8
| Install in the reverse order.
|
|
|
