Shown on left side of vehicle |
1 | Torsion bar linkage stabilizer bar |
2 | Nut |
N32.35-2008-03
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Remove/install | ||
1 | Raise vehicle | ||
2 | Unscrew nuts (2) from ball heads of respective torsion bar linkage stabilizer bar (1) | ||
| Notes on self-locking nuts and bolts | ||
If the threaded pin on the ball head turns too, counterhold threaded pin from front. | |||
Nut, torsion bar linkage for stabilizer bar to stabilizer bar | |||
Nut, torsion bar linkage to stabilizer bar on suspension strut | |||
Open wrench insert, (18 mm) | |||
Torque wrench handle | |||
3 | Remove torsion bar linkage stabilizer bar (1) | ||
| Check | ||
4 | Check ball heads and seal bellows of torsion bar linkage stabilizer bar (1) for wear and damage | Depending on findings, replace torsion bar linkage stabilizer bar (1). | |
5 | Install in the reverse order |
001 589 44 21 00
Torque wrench handle
000 589 30 01 00
Open wrench insert, (18 mm)