Shown on front axle with disk brake |
1 | Shock absorber |
2 | Nut |
3 | Screw |
4 | Front axle spring |
5 | Nut |
6 | Spring U-bolt |
7 | Spring seat |
8 | Spring support |
9 | Screw |
10 | Nut |
11 | Torsion bar |
12 | Bearing cap |
13 | Screw |
14 | Screw |
15 | Washer |
16 | Plastic bearing |
17 | Torsion bar linkage |
18 | Screw |
19 | Washer |
20 | Screw |
21 | Nut |
W32.20-0001-06
Danger | Risk of death caused by vehicle slipping or toppling off during lifting | Only lift vehicle at the lift support points specified by the vehicle manufacturer. | |
Topical note | Special instructions for lifting and supporting vehicle | ||
Topical note | Notes on self-locking nuts and bolts | ||
Notes on safety-relevant components | |||
| Remove/install | ||
1 | Secure vehicle to prevent it moving away. | ||
2 | Raise vehicle at front axle far enough so that wheels can turn freely, and jack up vehicle at vehicle frame. | Leave the front axle in raised state so that the front axle springs (4) are relieved. | |
3 | Remove shock absorbers (1). | ||
4 | Remove torsion bar (11) at front axle. | ||
5 | Remove spring U-bolts (6) and spring seat (7). | Installation: Replace nuts (10). | |
Nut, spring U-bolt to front axle | |||
6 | Unscrew nuts (5, 21) on front and rear spring brackets and drive out screws (3, 20) using a suitable drift. | Installation: Install new nuts (5, 21). | |
Threaded connection, front spring to spring bracket or length adjuster | |||
7 | Lower front axle and remove front axle spring (4) and spring pad (8) from axle. | Installation: Lightly grease mounting bore for center bolt in spring pad (8). | |
8 | Install in the reverse order |