P32.20-2138-06
5 Steering knuckle
8 Stabilizer bar pivot bushing
9 Rubber boot
10 Tie rod
17 Spring control arm
18 Torque strut
19 Rubber boot
23 Link rod
23b Nut
23c Nut
23d Screw
| Remove/install | ||
| Notes on self-locking nuts and bolts | ||
| When working on the front-end assembly, be careful not to scratch, mark or notch the surfaces of aluminum parts. Otherwise the service life of the parts will be affected | ||
Installation | Tighten nuts and bolts of chassis components only when vehicle is in ready-to-drive condition | ||
1 | Remove track rod (10) from steering knuckle (5). | Installation: Replace self-locking nut. | |
2 | Undo nut (23b) | To do so, counterhold the bolt (23d). Turn steering if necessary. | |
Installation: Tighten nut (23b) only when vehicle is in ready-to-drive condition. | |||
| |||
3 | Undo nut (23c), pry off link rod (23) from spring control arm (17) and swivel vertically upwards | Installation: Press the link rod (23) onto the spring control arm (17). | |
Up to chassis number 1A 17000, both link rods (23) must also be replaced. | |||
| |||
4 | Remove rubber boot (9) and wire fasteners of torsion bar pivot bushing (8) | If the torsion bar pivot bushing is pressed out with the rubber boot attached, the special tool will be damaged due to the high press-out force. | |
5 | Press stabilizer bar pivot bushing (8) out of spring control arm (17) | ||
6 | Install in the reverse order |
Front axle stabilizer bar