S27.60-4506-09
Shown without code XZ1 (Model generation 1) |
1 | Shift cable ball socket | 5 | Selector lever with bearing bracket | 9 | Electrical connector | ||
2 | Shift cable | 6 | Bolts | 10 | Electrical connector | ||
3 | Ball head | 7 | Plug-in connector | N15/5 | Electronic selector lever module control unit | ||
4 | Lock washer | 8 | Locking plate |
| Remove | ||
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Topical note | Notes on self-locking nuts and bolts | ||
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
1 | Remove selector lever handle with covering | ||
2 | Remove center console | ||
3 | Remove paneling on center console | ||
4 | Disconnect electrical connector (9) from electronic selector lever module control unit (N15/5) | ||
5 | Unscrew screws (6) and slide selector lever with bearing bracket (5) downwards out of guide | ||
6 | Use suitable tool to unclip shift cable ball socket (1) from ball head (3) on selector lever with bearing bracket (5) | ||
7 | Use suitable tool to pry shift cable (2) out of selector lever with bearing bracket (5) | ||
8 | Detach ignition lock cable from selector lever with bearing bracket (5) | To do so, press catch tab (8) together, push connector coupling (7) in direction of arrow, turn through 90° (to left or right) and detach opposite direction of arrow. | |
9 | Remove selector lever with bearing bracket (5) | ||
| Install | ||
10 | Insert adjustment tool into shift cable (2) | ||
| Adjustment tool for shift cable length adjuster | ||
11 | Install ignition lock cable on selector lever with bearing bracket (5) | Insert ignition lock cable into selector lever with bearing bracket (5) and turn through 90° (to left or right). Make sure that ignition lock cable is seated correctly. | |
12 | Clip shift cable ball socket (1) into ball head (3) on selector lever with bearing bracket (5) | Grease ball head (3) and shift cable ball socket (1). | |
Long-life grease | |||
13 | Guide shift cable (2) into selector lever with bearing bracket (5) and fix in place | Replace lock washer (4). | |
Make sure shift cable (2) is correctly seated. | |||
14 | Insert selector lever with bearing bracket (5) from below into guide and tighten screws (6) | Apply thread locking compound to thread of screws (6). | |
Model 639.603/703 with code MA0 (E-CELL 60 kW)Gearshift bracket to bulkhead support | |||
Model 636, 639 with transmission 722.6Gearshift bracket to bulkhead support | |||
Quick-acting adhesive, Loctite 270 | |||
15 | Connect electrical connector (9) to electronic selector lever module control unit (N15/5) | ||
16 | Detach adjusting tool from shift cable (2) | ||
| Check | ||
17 | Check gearshift system for proper operation and ease of movement | | |
Adjust gearshift system, if necessary. Refer to: | |||
| |||
Adjust shift and selector cable | |||
Adjust automatic transmission shift cable | |||
| Install | ||
18 | Install paneling on center console | ||
19 | Install center console | ||
20 | Install selector lever handle with cover |