P27.50-0261-09
33 Range selector lever
33a Shaft seal
34 Tapered rod
35 Detent plate
36 Torx screw
50 Linkage for parking lock shift lock
51 Pilot bushing
51a O-ring
51b Guide spring
52 Retaining ring
53 Park detent
54 Spring
55 Bearing bolt
55a O-ring
56 Retaining ring
60 Torx screw
139 Locking pawl
140 Torsion spring
141 Pin
141a O-ring
| Removing | ||
1 | Remove range selector lever, to do so remove bolt (60) | ||
2 | Remove detent plate with tapered rod (35, 34) | ||
3.1 | Unscrew bolt (36). | Except model 215, 220 | |
4.1 | Remove pin (141) | Except model 215, 220 | |
Pin is caulked | |||
5.1 | Pull linkage (50) out of transmission housing and unhook lock pawl (139) | Except model 215, 220 | |
6 | Remove retaining ring (52) of pilot bushing (51) | ||
7 | Push park detent (53) up against spring (54) and press pilot bushing (51)out of transmission housing using suitable tool | ||
8 | Remove retaining ring (56) and bearing pin (55) | ||
9 | Remove park detent (53) with spring (54) | ||
| Install | ||
10 | Insert park detent (53) and spring (54) into transmission housing and install bearing pin (55) with retaining ring (56) | Check O-ring (55a), replace if necessary | |
11 | Press park detent (53) up to end stop against the spring (54) and insert pilot bushing (51) into transmission housing, so that the park detent snaps into the pilot bushing's milled slot | Push pilot bushing far enough in until it engages | |
Check O-ring (51a), replace if necessary | |||
12 | Install circlip (52). | ||
13.1 | Plug linkage (50) into transmission housing and hook into the lock pawl (139) | Except model 215, 220 | |
14.1 | Install pin (141) | Except model 215, 220 | |
Pin must be caulked on the transmission housing side | |||
Check O-ring (141a), replace if necessary | |||
15.1 | Tighten screw (36) | Except model 215, 220 | |
| |||
16 | Insert detent plate with tapered rod (35 and 34) | ||
17 | Mount range selector lever (33) | Check sealing ring (33a), replace if necessary | |
| |||
|
Housing
Number | Designation | Transmission | ||
BA27.40-P-1006-01A | Bolt, detent plate to range selector lever | Nm | 8 | |
Housing
Number | Designation | Trans-mission | |
BA27.40-P-1008-01B | Bolt, detent plate to range selector lever | Nm | 8 |
Tightening torques for linkage for parking lock shift lock