Shown on transmission 725.0 with engine 256 except code M005 (4MATIC) |
1l | Oil line |
1r | Oil line |
2 | Oil cooler |
3 | Automatic transmission |
P27.55-2351-05
Shown on transmission 725.0 for engine 256 with code M005 (4MATIC) |
1l | Oil line |
1r | Oil line |
2 | Oil cooler |
3 | Automatic transmission |
P27.55-2352-05
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Notes on automatic transmission | |||
| Remove/install | ||
1 | Remove center and rear lower engine compartment lining. | ||
Installation: Only install center and rear lower rear engine compartment paneling again after leak test. | |||
2 | Thoroughly clean area around oil lines(1l, 1r) at oil cooler(2). | ||
3 | Detach oil lines(1l, 1r) from automatic transmission(3). | ||
Record plug | |||
4 | Seal openings in automatic transmission(3) using suitable stop plugs. | Record plug | |
5 | Detach oil lines (1l, 1r) from oil cooler (2) and remove downwards. | ||
Record plug | |||
6 | Seal openings in oil cooler(2) using suitable stop plugs. | Record plug | |
7 | Install in the reverse order | ||
8 | Check and correct oil level in automatic transmission(3). | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
9 | Perform engine test run and check oil lines(1l,1r) and oil cooler(2) for leak tightness. | ||
10 | Install center and rear lower engine compartment lining. |
129 589 00 91 00
Record plug