P27.55-A009-78
Shown on removed front axle |
1 | Oil line | 5 | Automatic transmission | 8 | Screw | ||
2 | Screw | 6 | Oil cooler | 9.1 | Bow | ||
3 | Oil line | 7 | Screw | 9.2 | Bracket | ||
4 | Screw |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Notes on automatic transmission | |||
| Remove/install | ||
1 | Remove front, center and rear lower engine compartment lining. | ||
Installation: Only install front, center and lower rear engine compartment lining again after a leak test. | |||
2 | Thoroughly clean connections of oil lines (1, 3) on automatic transmission (5) and oil cooler (6). | Assembly cleaner | |
3 | Remove screws (7, 8) and remove bracket (9.1) and holder (9.2). | Installation: Align bracket (9.1) and holder (9.2). | |
Bolt, clamp to oil line | |||
Bolt, clamp of oil cooler oil line to bracket | |||
4 | Remove screws (2, 4). | Installation: Align retaining clamps on oil lines (1, 3). | |
Screw, oil cooler oil line clamp to oil pan | |||
5 | Remove oil lines (1, 3) from oil cooler (6) and seal openings using suitable stop plugs. | ||
Collect the oil in a suitable container. | |||
Assembly cleaner | |||
Record plug | |||
6 | Remove oil lines (1, 3) from automatic transmission (5) and seal openings using suitable stop plugs. | ||
Collect the oil in a suitable container. | |||
Assembly cleaner | |||
Record plug | |||
7 | Route out oil lines (1, 3) and remove them. | ||
8 | Remove retaining clamps from oil lines (1, 3). | If the oil lines (1, 3) are replaced. | |
9 | Install in the reverse order. | ||
10 | Check oil level in the automatic transmission (5) using the ultrasound device, correct if necessary. | ||
| 000 588 09 19 00 Oil level sensor | ||
| Connect/disconnect diagnostic unit | ||
| 000 588 06 82 00 Oil dispenser | ||
| Automatic transmission fluids (ATF) (specification 236.17) | ||
MB Plastilube brake paste (brownish) | |||
Assembly cleaner | |||
Socket wrench | |||
Adapter | |||
| Check | ||
11 | Perform engine test run and check oil lines (1, 3), automatic transmission (5) and oil cooler (6) for leak tightness. | ||
12 | Install front, center and rear lower engine compartment lining. |
724 589 01 09 00
Socket wrench
725 589 03 90 00
Adapter
129 589 00 91 00
Record plug