1 | Oil cooling feed line |
2 | Oil cooling return line |
3 | Screw |
5 | Bracket |
7 | Automatic transmission fluid cooler |
D27.55-A013-76
1 | Oil cooling feed line |
2 | Oil cooling return line |
4 | Screw |
6 | Bracket |
8 | Automatic transmission |
D27.55-A014-76
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Notes on automatic transmission | |||
| Remove | ||
1 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
2 | Remove lower engine compartment paneling. | Model 907.6 with code XM1 (Noise abatement measures) | |
3 | Remove underfloor panels. | Model 907.6 with code XM1 (Noise abatement measures) | |
4 | Loosen screws (3, 4) and turn brackets (5, 6) through 90°. | ||
5 | Unhook oil cooler return line (2) from brackets (5, 6). | ||
6 | Remove oil cooler return line (2) from automatic transmission oil cooler (7) and seal openings with suitable stop plugs. | ||
Collect any transmission oil which runs out. | |||
Assembly cleaner | |||
Record plug | |||
7 | Remove oil cooler return line (2) from automatic transmission (8) and seal openings with suitable stop plugs. | ||
Collect any transmission oil which runs out. | |||
Assembly cleaner | |||
Record plug | |||
8 | Remove oil cooler return line (2). | ||
| Install | ||
9 | Position oil cooler return line (2) in installation position. | ||
10 | Remove stop plugs and attach oil cooler return line (2) to automatic transmission (8). | ||
11 | Remove stop plugs and attach oil cooler return line (2) to automatic transmission oil cooler (7). | ||
12 | Rotate brackets (5, 6) through 90° and tighten screws (3, 4). | Ensure correct installation position of oil cooler return line (2) and oil cooler feed line (1). | |
Screw, holder for oil lines to oil pan top section | |||
Screw, holder for oil lines to holder | |||
Concluding tasks | |||
13 | Check/correct transmission oil level. | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
14 | Perform engine test run; when doing so, check oil cooler return line (2) for leak tightness. | ||
15 | Install underfloor paneling. | Model 907.6 with code XM1 (Noise abatement measures) | |
16 | Install lower engine compartment paneling. | Model 907.6 with code XM1 (Noise abatement measures) | |
129 589 00 91 00
Record plug