AR27.50-S-0810S | Disassemble/assemble output shaft with center and rear gear set | 25.5.10 |
TRANSMISSION 722.6 in MODEL 636, 639
D27.50-1120-09
2 Teflon rings
3 Needle cage
4 Thrust plate
5 Rear gear set
10 Thrust plate
11 Circlip
12 Needle roller bearing
6 Rear hollow shaft
7 K3 clutch
8 Thrust plate
9 Needle roller bearing
| Disassemble/assemble | ||
1 | Remove main components of transmission | ||
2 | Remove needle roller bearing (12). | ||
3 | Remove locking ring (11) | Circlip pliers for external circlip | |
4 | Remove thrust washer (10), needle roller bearing (9) and thrust washer (8). | ||
5 | Remove K3 clutch (7). | According to findings: | |
Disassemble/assemble K3 clutch (7). | |||
6 | Remove rear hollow shaft (6). | According to findings: | |
Disassemble/assemble rear hollow shaft (6) with rear freewheel. | |||
7 | Remove teflon rings (2). | Installation: install new teflon rings (2). | |
8 | Remove thrust washer (4). | Installation: note installation position. | |
9 | Remove needle cage (3). | ||
10 | Assemble in the reverse order | ||
| Checking | ||
11 | Check axial play between shim and circlip, adjust if necessary. | ||
Axial play between shim and circlip | |||
Feeler gauge |
Test values for gear set