AR27.50-P-0850A | Disassembling and assembling rear hollow shaft with rear freewheel | 24.1.95 |
TRANSMISSION 722.6
P27.50-0257-06
45a Hollow shaft
45b O-rings
45c Snap ring
45d Freewheel
45e Rear sun gear with internally toothed disk carrier/clutch K3
45f Axial needle roller bearing (not applicable as of 06.99)
45g Shim (not applicable as of 06.99)
45h Circlip
| Disassemble/assemble | ||
1 | Detach transmission housing from torque converter housing | ||
2 | Remove multi-disk clutch K1, K2 and K3 | ||
3 | Remove circlip (45h), shim (45g), axle needle roller bearing (45f) from hollow shaft (45a). | Installation: Check that circlip is correctly seated. | |
Check O-rings (45b), replace if necessary. | |||
If using BT27.50-P-0011-01A, axial needle roller bearing and shim are no longer required. | |||
4 | Remove rear sun gear (45e) with internally toothed disk carrier / K3 and rear freewheel (45d). | Installation: Install hollow shaft (45a) on freewheel and press in while turning counterclockwise | |
| Friction bearing in sun gear of rear planetary gearset converted to anti-friction bearing | Transmission 722.6 | |
5 | Remove snap ring (45c) for freewheel | ||
6 | Press freewheel out of sun gear. | Installation: The thrust plate of the freewheel (45d) must face the snap ring (45c). | |
7 | Assemble in reverse order |